STRUCTUREBOND | CLEANER
Quick & Efficient Cleaning of the StructureBond Adhesive Gun
This high-grade cleaning solution will rid the StructureBond application gun from any uncured polyurethane foam adhesive.
- Specifically Adapted to the StructureBond Application Gun
- Makes the Removal of Uncured Adhesive on any Solvent-Resistant Material Fast and Easy
- Keeps your Application Gun Squeaky Clean Until the Next Application
The StructureBond Cleaner solution makes the cleaning of the Gun II foam adhesive applicator fast and easy, simply follow these simple steps!
To clean the Gun II applicator
1. Remove the StructureBond Adhesive container from the application dispenser
2. Screw on a StructureBond Cleaner canister and pull the trigger a few times to fill the gun
3. Allow the StructureBond Cleaner to remain into the dispenser for approximately 15 minutes
4. Pull the trigger until the cleaning solution comes out clear
5. Remove the StructureBond Cleaner canister and store it
6. Wipe up the gun until it's completely fry and store it until further usage.
To remove non-cured STRUCTURE BOND adhesive:
1. Attach a spray nozzle to the cleaner canister.
2. Press nozzle with finger and spray cleaner on the area to be cleaned.
3. Remove nozzle when finished
Gun is easily cleaned with practical cleaner cartridge available from Techniseal.
AFTER USING THE STRUCTURE BOND GUN:
If there is still product in the container:
Close the valve of the Structure Bond Gun and leave the container on the gun until the next job.
If the container is empty:
Remove the container from the gun to avoid the product from drying and clogging the gun. This may render the gun unusable (see photo).
Then, screw a new container of adhesive to the gun and continue using it if necessary. If gun is to be stored away, pull the trigger a few seconds to make sure the gun is filled with the new adhesive, which will prevent it from drying.
For optimal performance, Techniseal recommends screwing a container of Structure Bond cleaner to the gun and pulling the trigger to clean the gun thoroughly, before adding a new container of adhesive.
Estimate how much product you will need
We are sorry, there is no calculator for this product.