STRUCTUREBOND | GUN II DISPENSER
Specifically Conceived For the StructureBond Foam Adhesive
With the Gun II dispenser, the StructureBond Foam adhesive really is the easiest, fastiest and cleanest way to apply adhesive on any construction, masonry or hardscape project. This applicator was specifically developed to address professionals needs and expectations.
- Gives you unmatched precision
- Provides total control on the product during application
- Built with high-quality, durable and lightweight materials
- Conceived to minimize product waste and unwanted spillage
Use the GUN II dispenser to apply the STRUCTURE BOND hardscape foam adhesive to any outdoor surface. This top-notch tool enables you to gain access to hard-to-reach areas and greatly limits excessive spillage or dripping.
Use the STRUCTURE BOND gun cleaner solution to keep your dispenser in optimal condition.
Gun is easily cleaned with practical cleaner cartridge available from Techniseal.
AFTER USING THE STRUCTURE BOND GUN:
If there is still product in the container:
Close the valve of the Structure Bond Gun and leave the container on the gun until the next job.
If the container is empty:
Remove the container from the gun to avoid the product from drying and clogging the gun. This may render the gun unusable (see photo).
Then, screw a new container of adhesive to the gun and continue using it if necessary. If gun is to be stored away, pull the trigger a few seconds to make sure the gun is filled with the new adhesive, which will prevent it from drying.
For optimal performance, Techniseal recommends screwing a container of Structure Bond cleaner to the gun and pulling the trigger to clean the gun thoroughly, before adding a new container of adhesive.
Estimate how much product you will need
We are sorry, there is no calculator for this product.